• "

Ordering

目录wLW嘉泰姆

1.产品概述                       2.产品特点wLW嘉泰姆
3.应用范围                       4.下载产品资料PDF文档 wLW嘉泰姆
5.产品封装图                     6.电路原理图                   wLW嘉泰姆
7.功能概述                        8.相关产品wLW嘉泰姆

一,产品概述(General Description)   wLW嘉泰姆

  The CXSD62131 CXSD62131A CXSD62131C consists of two independent 1.5MHz constant frequency, current mode, and PWM step-down converters. Each converter integrates a main switch with a synchronous rectifier for high efficiency without an external Schottky diode. The CXSD62131  is ideal for powering portable equipment that runs from a single cell Lithium Ion (Li+) battery. Each converter can supply 1A of load current from a 2.7V to 5.5V input voltage. The output voltage can be regulated as low as 0.6V. The CXSD62131 can also run at 100% duty cycle for low dropout applications.wLW嘉泰姆
二.产品特点(Features)wLW嘉泰姆

1A Output Current on Each ChannelwLW嘉泰姆
2.7V to 5.5V Input Voltage RangewLW嘉泰姆
1.5MHz Constant Frequency OperationwLW嘉泰姆
Low Dropout Operation at 100% Duty CyclewLW嘉泰姆
Synchronous TopologywLW嘉泰姆
0.6V Low Reference VoltagewLW嘉泰姆
Current Mode OperationwLW嘉泰姆
Over-Temperature ProtectionwLW嘉泰姆
Over-Current ProtectionwLW嘉泰姆
Up to 94% EfficiencywLW嘉泰姆
Internally CompensatedwLW嘉泰姆
Lead Free and Green Devices AvailablewLW嘉泰姆
(RoHS Compliant)wLW嘉泰姆
三,应用范围 (Applications)wLW嘉泰姆

TV Tuner/BoxwLW嘉泰姆
Portable InstrumentwLW嘉泰姆
四.下载产品资料PDF文档 wLW嘉泰姆

需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！wLW嘉泰姆

 wLW嘉泰姆

五,产品封装图 (Package)wLW嘉泰姆

wLW嘉泰姆

六.电路原理图wLW嘉泰姆

wLW嘉泰姆

七,功能概述wLW嘉泰姆

Main Control LoopwLW嘉泰姆
The CXSD62131 has dual independent constant frequency,current-mode PWM step-down converters. During nor-wLW嘉泰姆
mal operation, the internal P-channel power MOSFET is turned on each cycle when the oscillator sets an internalwLW嘉泰姆
RS latch and is turned off when an internal comparator (ICMP) resets the latch. The peak inductor current at whichwLW嘉泰姆
ICMP resets the RS latch is controlled by the voltage on the COMP, which is the output of the error amplifierwLW嘉泰姆
(EAMP). An external resistive divider connected between VOUT and ground allows the EAMP to receive an outputwLW嘉泰姆
feedback voltage VFB at FB pin. When the load current increases, it causes a slightly decrease in VFB associatedwLW嘉泰姆
with the 0.6V reference, which in turn causes the COMP voltage to increase until the average inductor currentwLW嘉泰姆
matches the new load current.wLW嘉泰姆
Soft-StartwLW嘉泰姆
Each channel in the CXSD62131 has a built-in soft-start to control the output voltage rise during start-up. During soft-start, an internal ramp, connected to the one of the posi- tive inputs of the error amplifier, raise up to replace the reference voltage (0.6V typical) until the ramp voltage reaches the reference voltage.wLW嘉泰姆
Short Circuit ProtectionwLW嘉泰姆
For each channel, when the output is shortened to the ground, the frequency of the oscillator will be reduced towLW嘉泰姆
210kHz. This lower frequency allows the inductor current to safely discharge, thereby preventing current runaway.wLW嘉泰姆
The oscillator’s frequency will gradually increase to its designed rate when the feedback voltage on the FB againwLW嘉泰姆
approaches 0.6V.wLW嘉泰姆
Over-Temperature Protection (OTP) wLW嘉泰姆
For each channel, the over-temperature circuit limits the junction temperature of the CXSD62131. When the junctionwLW嘉泰姆
temperature exceeds 150oC, a thermal sensor turns off the power MOSFETs, allowing the channels to cool down.wLW嘉泰姆
The thermal sensor allows the converter to start a soft-start process and to regulate the output voltage againwLW嘉泰姆
after the junction temperature cools by 40ïC. The OTP is designed with a 40ïC hysteresis to lower the averagewLW嘉泰姆
Junction Temperature (TJ) during continuous thermal overload conditions, increasing the lifetime of the device.wLW嘉泰姆
 Enable/ShutdownwLW嘉泰姆
For each channel, driving EN to the ground places the channel in shutdown mode. When in shutdown, the inter-wLW嘉泰姆
nal power MOSFETs are turned off, all internal circuitry shuts down, and the quiescent supply current reduces towLW嘉泰姆
1μA maximally.wLW嘉泰姆
Automoatic PFM/PWM mode SwitchwLW嘉泰姆
The CXSD62131 is a fixed frequency PWM peak current modulation control step-down converter. At light loads,wLW嘉泰姆
the CXSD62131 will automatically enter in pulse frequency modulation operation to reduce the dominant switchingwLW嘉泰姆
losses. In PFM operation, the inductor current may reach zero or reverse on each pulse. A zero current comparatorwLW嘉泰姆
turns off the N-channel synchronous MOSFET, forcing DCM (Discontinuous Current Mode) operation at lightwLW嘉泰姆
load. These controls get very low quiescent, help to main-tain high efficiency over the complete load range.wLW嘉泰姆
八,相关产品                       更多同类产品.......wLW嘉泰姆

◀ Previous:1.5MHz high efficiency monolithic synchronous buck regulator. Design with current mode scheme,CXSD62130 CXSD62130A stable with ceramic output capacitor.

Back to top

Next▶:CXSD62131 CXSD62131A CXSD62131C consists of two independent 1.5MHz constant frequency, current mode, and PWM step-down converters. Each converter integrates a main switch