• "

Ordering

目录K9n嘉泰姆

1.产品概述                       2.产品特点K9n嘉泰姆
3.应用范围                       4.下载产品资料PDF文档 K9n嘉泰姆
5.产品封装图                     6.电路原理图                   K9n嘉泰姆
7.功能概述                        8.相关产品K9n嘉泰姆

 K9n嘉泰姆

一,产品概述(General Description)         K9n嘉泰姆
   CXSU63039 is a high efficiency synchronous boost regulator that convertsK9n嘉泰姆

down to 2.5V input and up to 5.5V output voltage. It adopts NMOS for theK9n嘉泰姆

main switch and PMOS for the synchronous switch. It can disconnect the K9n嘉泰姆

output from input during the shutdown mode..K9n嘉泰姆

  It integrates 5A power MOSFET and can output 5V 2.5A with Li-Battery input.K9n嘉泰姆
二.产品特点(Features)K9n嘉泰姆
1.)2.5V Minimum input voltageK9n嘉泰姆
2.)Adjustable output voltage from 3V to 5.5VK9n嘉泰姆
3.)6A peak current limitK9n嘉泰姆
4.)Input under voltage lockoutK9n嘉泰姆
5.)600Khz fixed Switching FrequencyK9n嘉泰姆
6.)Load disconnect during shutdownK9n嘉泰姆
7.)Integrated soft-startK9n嘉泰姆
8.)Output over voltage protectionK9n嘉泰姆
30moJTM Power MOSFETK9n嘉泰姆
Thermal ShutdownK9n嘉泰姆
QFN4x4-16 PackageK9n嘉泰姆
三,应用范围 (Applications)K9n嘉泰姆
1.) Handheld DevicesK9n嘉泰姆
2.)Power BankK9n嘉泰姆
3.)All Single Cell Li or Dual Cell Battery Operated ProductsK9n嘉泰姆
四,产品封装图 (Package)K9n嘉泰姆
K9n嘉泰姆
K9n嘉泰姆

五,电路原理图K9n嘉泰姆
K9n嘉泰姆
K9n嘉泰姆
K9n嘉泰姆
六.产品PDF文档K9n嘉泰姆

需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！K9n嘉泰姆

 K9n嘉泰姆

七,功能概述K9n嘉泰姆

SYNCHRONOUS RECTIFIERK9n嘉泰姆
The device integrates an N-channel and a P-channel MOSFET transistor to realize aK9n嘉泰姆
synchronous rectifier. Because the commonly used discrete Schottky rectifier is replaced withK9n嘉泰姆
a low RDS(ON) PMOS switch, the power conversion efficiency reaches 96%. To avoidK9n嘉泰姆
ground shift due to the high currents in the NMOS switch, two separate ground pins are used.K9n嘉泰姆
The reference for all control functions is the GND pin. The source of the NMOS switch isK9n嘉泰姆
connected to PGND. Both grounds must be connected on the PCB at only one point close toK9n嘉泰姆
the GND pin. A special circuit is applied to disconnect the load from the input duringK9n嘉泰姆
shutdown of the converter. In conventional synchronous rectifier circuits, the backgate diodeK9n嘉泰姆
of the high-side PMOS is forward biased in shutdown and allows current flowing from theK9n嘉泰姆
battery to the output. This device however uses a special circuit which takes the cathode ofK9n嘉泰姆
the backgate diode of the high-side PMOS and disconnects it from the source when theK9n嘉泰姆
regulator is not enabled (EN = low).K9n嘉泰姆
The benefit of this feature for the system design engineer is that the battery is not depletedK9n嘉泰姆
during shutdown of the converter. No additional components have to be added to the designK9n嘉泰姆
to make sure that the battery is disconnected from the output of the converter.K9n嘉泰姆
八,相关产品           更多同类产品........    K9n嘉泰姆

 K9n嘉泰姆

◀ Previous:CXSU63038A high efficiency synchronous boost regulator that converts down to 2.5V input and up to 5.5V output voltage. It adopts NMOS for the main switch and PMOS for the synchronous switch

Back to top

Next▶:5V 6A 1.2MHz Synchronous Boost Converter CXSU63040 is a synchronous rectifier,fixed switching frequency (1.2MHz typical), and current‐mode step‐up regulator. The device allows use of small inductors