CXSD62159 is a 2A synchronous buck converter with integrated power MOSFETs. The CXSD62159 design with a current-mode control scheme, can convert wide input voltage of 4.5V to 24V to the output voltage adjustable from 0. 8V to 20V to provide excellent output voltage regulation. The CXSD62159 is equipped with an automatic PFM/PWM mode operation. At light load, the IC operates in the PFM mode to reduce the switching losses. At heavy load, the IC works in PWM. The CXSD62159 is also equipped with Power-on-reset, softstart, soft-stop, and whole protections (under-voltage, over-temperature, and current-limit) into a single package. This device, available TDFN3x3-10, provides a very compact system solution external components and PCB area
Main Control Loop
The CXSD62159 is a constant frequency current mode switching regulator.
During normal operation, the internal N-channel power MOSFET is turned on
each cycle when the oscillator sets an internal RS latch and would be turned
off when an internal current comparator (ICMP) resets the latch. The peak
inductor current at which ICMP resets the RS latch is controlled by the voltage
on the COMP pin, which is the output of the error amplifier (EAMP). An external
resistive divider connected between VOUT and ground allows the EAMP to
receive an output feedback voltage VFB at FB pin. When the load current
increases, it causes a slight decrease in VFB relative to the 0.8V reference,
which in turn causes the COMP voltage to increase until the average inductor
current matches the new load current.
VIN Power-On-Reset (POR) and EN Under-voltageLockout
The CXSD62159 keep monitoring the voltage on VIN pin to prevent wrong logic
operations which may occur when VIN voltage is not high enough for the internal
control circuitry to operate. The VIN POR has a rising threshold of 4.05V (typical)
with 0.3V of hysteresis.An external under-voltage lockout (UVLO) is sensed at
the EN pin. The EN UVLO has a rising threshold of 2.5V with 0.2V of hysteresis.
The EN pin should be connected a resistor divider from VIN to EN .After the VIN
and EN voltages exceed their respective voltage thresholds, the IC starts a
start-up process and then ramps up the output voltage to the setting of output
voltage.
-
"
1.产品概述 2.产品特点
3.应用范围 4.下载产品资料PDF文档
5.产品封装图 6.电路原理图
7.功能概述 8.相关产品
|
一,产品概述(General Description) CXSD62159 is a 2A synchronous buck converter with integrated power MOSFETs. The CXSD62159 design with a current-mode control scheme, can convert wide input voltage of 4.5V to 24V to the output voltage adjustable from 0. 8V to 20V to provide excellent output voltage regulation. The CXSD62159 is equipped with an automatic PFM/PWM mode operation. At light load, the IC operates in the PFM mode to reduce the switching losses. At heavy load, the IC works in PWM. The CXSD62159 is also equipped with Power-on-reset, softstart, soft-stop, and whole protections (under-voltage, over-temperature, and current-limit) into a single package. This device, available TDFN3x3-10, provides a very compact system solution external components and PCB area Main Control Loop The CXSD62159 is a constant frequency current mode switching regulator. LCD Monitor/TV Set-Top Box 四.下载产品资料PDF文档 需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！
五,产品封装图 (Package)
六.电路原理图
|
七,功能概述
CXSD62159 is a 2A synchronous buck converter with integrated power MOSFETs. The CXSD62159 design with a cur-
rent-mode control scheme, can convert wide input voltage of 4.5V to 24V to the output voltage adjustable from 0.
8V to 20V to provide excellent output voltage regulation.The CXSD62159 is equipped with an automatic PFM/PWM
mode operation. At light load, the IC operates in the PFM mode to reduce the switching losses. At heavy load, the
IC works in PWM.
The CXSD62159 is also equipped with Power-on-reset, softstart, soft-stop, and whole protections (under-voltage,
over-temperature, and current-limit) into a single package.This device, available TDFN3x3-10, provides a very com-
pact system solution external components and PCB area
八,相关产品 更多同类产品.......
|
Switching Regulator > Buck Converter |
|||||||||||
|
Part_No |
Package |
Architectu |
No.of PWM Outpu |
Drive Lout (A) |
Vin(V) |
Fmax Khz |
Vref (V) |
R-Top (milohm) |
R-Sync (milohm) |
Iq (No load) (uA) |
|
|
min |
max |
||||||||||
|
TQFN5x6-28 |
CM |
1 |
5 |
4.5 |
26 |
380 |
0.8 |
50 |
20 |
1000 |
|
|
SOP-8 |
CM |
1 |
2 |
4.5 |
26 |
380 |
0.8 |
100 |
1000 |
||
|
SOP-8P |
CM |
1 |
4 |
4.5 |
26 |
380 |
0.8 |
80 |
1000 |
||
|
SOT23-5|TSOT23-5 |
CM |
1 |
1 |
2.7 |
6 |
1500 |
0.6 |
280 |
250 |
25 |
|
|
SOT23-5 |
CM |
1 |
1 |
2.7 |
6 |
1500 |
0.6 |
280 |
250 |
||
|
SOP-8 |
CM |
1 |
3 |
4.3 |
14 |
500 |
0.8 |
70 |
70 |
500 |
|
|
SOP-8P |
CM |
1 |
3 |
4.3 |
14 |
500 |
0.8 |
55 |
45 |
500 |
|
|
TDFN3x3-10 |
3 |
2.6 |
5.5 |
2000 |
0.8 |
110 |
110 |
460 |
|||
|
TDFN3x3-10 |
CM |
2 |
1 |
2.7 |
6 |
1500 |
0.6 |
280 |
250 |
500 |
|
|
TDFN3x3-10 |
CM |
2 |
1 |
2.7 |
6 |
1500 |
0.6 |
280 |
250 |
||
|
TDFN2x2-6 |
CM |
1 |
1 |
2.7 |
6 |
1500 |
0.6 |
280 |
250 |
25 |
|
|
TDFN2x2-6 |
CM |
1 |
1 |
2.7 |
6 |
1500 |
0.6 |
280 |
250 |
||
|
TDFN3x3-12 |
CM |
2 |
1 |
2.7 |
6 |
1500 |
0.6 |
280 |
250 |
25 |
|
|
TDFN3x3-12 |
CM |
2 |
1 |
2.7 |
6 |
1500 |
0.6 |
280 |
250 |
||
|
TDFN 3x3 12 |
CM |
2 |
1 |
3 |
5.5 |
1500 |
0.6 |
280 |
250 |
30 |
|
|
TQFN3x3-20 |
CM |
3 |
2 |
2.9 |
5.5 |
1500 |
0.6 |
- |
- |
300 |
|
|
TDFN2x2-8 |
CM |
1 |
1 |
3.3 |
8 |
1500 |
0.6 |
280 |
250 |
25 |
|
|
SOP-8 |
CM |
1 |
2 |
4.5 |
24 |
340 |
0.925 |
110 |
110 |
1900 |
|
|
SOP-8P |
|||||||||||
