The CXSD6278 is a 300kHz constant frequency voltagemode synchronous switching controller that drives exter-nal N-channel MOSFETs. When the input supply dropsclose to output, the upper MOSFET remains on, achiev-ing 100% duty cycle. Internal loop compensation is opti-mized for fast transient response, eliminating externalcompensation network. The precision 0.8V referencemakes this part suitable for a wide variety of low voltageapplications. Soft-start is internally set to 2ms, limitingthe input in-rush current and preventing the output fromovershoot during powering up.The CXSD6278 has over current and short circuitprotections. Over current protection is achieved by moni-toring the voltage drop across the high side MOSFET,eliminating the need for a current sensing resistor andshort circuit condition is detected through the FB pin. Ifeither fault conditions occur, the CXSD6278 would initiatethe soft-start cycle. After three cycles and if the fault condi-tion persists, the controller will be shut down. To restartthe controller, either recycle the VCC supply or momen-tarily pull the OSCSET pin below 1.25V.The CXSD6278 can be shutdown by pulling the OCSETpin below 1.25V. In shutdown, both gate drive signals willbe low. The controller is available in a small SOP-8package.
产品特点 返回TOP
-
"
目录
7.相关产品
产品概述 返回TOP
The CXSD6278 is a 300kHz constant frequency voltagemode synchronous switching controller that drives exter-nal N-channel MOSFETs. When the input supply dropsclose to output, the upper MOSFET remains on, achiev-ing 100% duty cycle. Internal loop compensation is opti-mized for fast transient response, eliminating externalcompensation network. The precision 0.8V referencemakes this part suitable for a wide variety of low voltageapplications. Soft-start is internally set to 2ms, limitingthe input in-rush current and preventing the output fromovershoot during powering up.The CXSD6278 has over current and short circuitprotections. Over current protection is achieved by moni-toring the voltage drop across the high side MOSFET,eliminating the need for a current sensing resistor andshort circuit condition is detected through the FB pin. Ifeither fault conditions occur, the CXSD6278 would initiatethe soft-start cycle. After three cycles and if the fault condi-tion persists, the controller will be shut down. To restartthe controller, either recycle the VCC supply or momen-tarily pull the OSCSET pin below 1.25V.The CXSD6278 can be shutdown by pulling the OCSETpin below 1.25V. In shutdown, both gate drive signals willbe low. The controller is available in a small SOP-8package.
产品特点 返回TOP
• Operates from +5V Input
• 0.8V Internal Reference Voltage
- ±1.5% Accuracy Over Line, Load and Temperature
• 0.8V to VCC Output Range
• Full Duty Cycle Range
- 0% to 100%
• Internal Loop Compensation
• Internal Soft-Start
- Typical 2ms
• Programmable Over-Current Protection
- Lossless Sensing Using MOSFET RDS (ON)
• Under-Voltage Protection
• Drives External N-Channel MOSFETs
• Shutdown Control
• Small SOP-8 Package
• Lead Free and Green Devices Avaliable
(RoHS Compliant)
应用范围 返回TOP
• Motherboard
• Graphics Cards
• Cable or DSL Modems, Set Top Boxes
• DSP Supplies
• Memory Supplies
• 5V Input DC-DC Regulators
• Distributed Power Supplies
技术规格书（产品PDF) 返回TOP
需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！
产品封装图 返回TOP
电路原理图 返回TOP
相关芯片选择指南 返回TOP 更多同类产品......
|
Switching Regulator > Buck Controller |
|||||||||||
|
Part_No |
Package |
Topology |
Archi tectu |
Phase |
No.of PWM Output |
Output Current (A) |
Input Voltage (V) |
Reference Voltage (V) |
Bias Voltage (V) |
Quiescent Current (uA) |
|
|
min |
max |
||||||||||
|
SOP-14|QSOP-16 QFN4x4-16 |
Buck |
VM |
1 |
1 |
30 |
2.9 |
13.2 |
0.9 |
12 |
8000 |
|
|
SOP-8 |
Buck |
VM |
1 |
1 |
20 |
2.9 |
13.2 |
0.8 |
12 |
5000 |
|
|
SOP-8 |
Buck |
VM |
1 |
1 |
20 |
2.9 |
13.2 |
0.8 |
12 |
5000 |
|
|
QFN4x4-24 |
Multiphase |
VM |
2 |
1 |
60 |
3.1 |
13.2 |
0.6 |
12 |
5000 |
|
|
SOP-8 |
Buck |
VM |
1 |
1 |
20 |
2.2 |
13.2 |
0.8 |
5~12 |
2100 |
|
|
SOP-8 |
Buck |
VM |
1 |
1 |
20 |
2.2 |
13.2 |
0.8 |
5~12 |
2100 |
|
|
SOP8|TSSOP8 |
Buck |
VM |
1 |
1 |
5 |
5 |
13.2 |
1.25|0.8 |
5~12 |
3000 |
|
|
SOP-8 |
Buck |
VM |
1 |
1 |
10 |
3.3 |
5.5 |
0.8 |
5 |
2100 |
|
|
SOP-14 |
Buck |
VM |
1 |
1 |
10 |
5 |
13.2 |
0.8 |
12 |
2000 |
|
|
TSSOP-24 |QFN5x5-32 |
Buck |
VM |
1 |
2 |
20 |
5 |
13.2 |
0.6 |
5~12 |
4000 |
|
|
SOP14|QSOP16 |QFN-16 |
Buck |
VM |
1 |
1 |
30 |
2.9 |
13.2 |
0.9 |
12 |
4000 |
|
|
SOP-14 |
Buck |
VM |
1 |
1 |
30 |
2.2 |
13.2 |
0.6 |
12 |
5000 |
|
|
SOP-14 |
Buck |
VM |
1 |
1 |
30 |
2.2 |
13.2 |
0.6 |
12 |
5000 |
|
|
SOP-14 |
Buck |
VM |
1 |
1 |
25 |
2.2 |
13.2 |
0.8 |
12 |
5000 |
|
|
LQFP7x7 48 |TQFN7x7-48 |
Buck|Boost |Flyback |
VM |
1 |
6 |
0.015 |
1.4 |
6.5 |
- |
5 |
1800 |
|
|
TSSOP-24P |
Buck |
VM |
1 |
2 |
20 |
2.97 |
5.5 |
0.8 |
5~12 |
5000 |
|
|
SOP-14 |
Buck |
VM |
1 |
1 |
10 |
5 |
13.2 |
0.8 |
12 |
3000 |
|
|
SOP-8-P|DIP-8 |
Buck |
VM |
1 |
1 |
30 |
2.9 |
13.2 |
1.2 |
12 |
3000 |
|
|
SSOP28 QFN4x4-24 |
Buck |
VM |
1 |
2 |
20 |
5 |
24 |
0.9 |
5 |
1200 |
|
|
SOP-20 |
Buck |
VM |
1 |
2 |
20 |
2.2 |
13.2 |
0.6 |
5~12 |
4000 |
|
|
SOP8|DFN3x3-10 |
VM |
1 |
2 |
- |
- |
- |
- |
5~12 |
550 |
||
|
DIP8|SOP-8 |
Buck|Boost |Flyback |Forward |
VM |
1 |
1 |
1 |
1.2 |
9 |
24 |
5 |
9 ~ 24 |
|
|
SSOP16|QFN4x4-16 |TQFN3x3-16 |
Buck |
VM |
1 |
1 |
25 |
3 |
25 |
0.6 |
5 |
1700 |
|
|
TDFN3x3-10 |
Buck |
COT |
1 |
1 |
25 |
3 |
25 |
0.5 |
5 |
350 |
|
|
QFN4x4-24 |
Buck |
CM |
2 |
1 |
40 |
4.5 |
13.2 |
0.6 |
5~12 |
4000 |
|
|
SOP8P|TDFN3x3-10 |
Buck |
VM |
1 |
1 |
20 |
3 |
13.2 |
0.8 |
5~12 |
2500 |
|
|
SOP8P |
Buck |
VM |
1 |
1 |
25 |
3 |
13.2 |
0.6|0.8 |
5~12 |
1200 |
|
|
TDFN3x3-10 |
Buck |
VM |
1 |
1 |
25 |
4 |
13.2 |
0.8 |
5~12 |
2000 |
|
|
TDFN3x3-10 |
Buck |
COT |
1 |
1 |
25 |
4.5 |
25 |
0.6 |
5~12 |
80 |
|
|
SOP-8P |
Buck |
VM |
1 |
1 |
25 |
4.5 |
13.2 |
0.8 |
5~12 |
16000 |
|
|
TQFN3x3-10 |
Buck |
VM |
1 |
1 |
25 |
4.5 |
13.2 |
0.6 |
5~12 |
2500 |
|
|
TDFN3x3-10 |
Buck |
COT |
1 |
1 |
30 |
3 |
25 |
0.8 |
5~12 |
2000 |
|
|
TQFN3x3-16 |
Buck |
COT |
1 |
1 |
30 |
1.8 |
28 |
0.6 |
5 |
600 |
|
|
TQFN 3x3 16 |
Buck |
COT |
1 |
1 |
30 |
1.8 |
28 |
0.6 |
5 |
600 |
|
|
QFN4x4-24 |
|||||||||||
