Product information query
Products News
首页 > Products > Battery Charging Chip > USB Interface Circuit > USB Switch > The CXUS7743 incorporates dual 100mΩ P-channel MOSFET power switches for power-distribution systems that require multiple power switches in a single package. Each switch is controlled by a logic enable input
The CXUS7743 incorporates dual 100mΩ P-channel MOSFET power switches for power-distribution systems that require multiple power switches in a single package. Each switch is controlled by a logic enable input

The CXUS7743 incorporates dual 100mΩ P-channel MOSFET power switches for power-distribution systems that require multiple power switches in a single package. Each switch is controlled by a logic enable input. When either output load exceeds the current-limit threshold or a short is present, the device limits the outputs current to a safe level by switching into a constant-current limit mode with fold back, pulling the over-current (OCB(s)) logic output low. When continuous heavy overloads or short-circuits increase the power dissipation in the switches, causing the junction temperature to raise, a thermal protection circuit shutdown the switches to prevent damage. Internal Under Voltage Lock-Out (UVLO) circuitry ensures that the switches remain off until valid input voltage is present. Each power switch is designed to set current limit at 1A_typical for CXUS7743 and 2.5A_typical for CXUS7743-15 respectively

 The CXUS7743 incorporates dual 100mΩ P-channel MOSFET power switches for power-distribution systems that require multiple power switches in a single package. Each switch is controlled by a logic enable input
Manual
Ordering

Ordering

Product introduction

目录

1.产品概述       2.产品特点     cF9嘉泰姆

3.应用范围       4.技术规格书下载(PDF文档)cF9嘉泰姆

5.产品封装       6.电路原理图  cF9嘉泰姆

7.相关产品cF9嘉泰姆

   产品概述 返回TOPcF9嘉泰姆


      CXUS7743是一种双信道的电源开关芯片,内部集成了两个100mΩ 的P型MOSFET功率管,每个信道各有一个逻辑使能控制信号。当负载超出限制范围或者有短路情况发生的时候,芯片会进入限流模式,把负载电流控制在安全区域内,同时拉低限流指示信号OCB(s),CXUS7743和CXUS7743-15每个通道的限流电流设置典型值分别为1A和2.5A。并且具有fold back功能;如果持续存在超重负载或者短路情况,芯片内部温度和功耗将迅速上升,芯片将检测到过温状况,并自动进入保护状态,切断功率信道以防止芯片损毁;另外,CXUS7743还具有检测输入电源的功能,功率管会维持关断直到电源电压超过欠压阈值范围。OCB(s)是具有开漏输出的限流标记引脚,8ms的延时功能可以屏蔽错误的限流信号,防止芯片向主机系统发出错误的指示。例如大电容负载接入导致的短期限流情况的发生。CXUS7743可以在芯片关断的时候阻断反向电流的发生。CXUS7743封装采用MSOP-8或SOP-8封装。The CXUS7743 incorporates dual 100mΩ P-channel MOSFET power switches for power-distribution systems that require multiple power switches in a single package. Each switch is controlled by a logic enable input. When either output load exceeds the current-limit threshold or a short is present, the device limits the outputs current to a safe level by switching into a constant-current limit mode with fold back, pulling the over-current (OCB(s)) logic output low. When continuous heavy overloads or short-circuits increase the power dissipation in the switches, causing the junction temperature to raise, a thermal protection circuit shutdown the switches to prevent damage. Internal Under Voltage Lock-Out (UVLO) circuitry ensures that the switches remain off until valid input voltage is present. Each power switch is designed to set current limit at 1A_typical for CXUS7743 and 2.5A_typical for CXUS7743-15 respectively. OCB(s) are open-drain outputs which are asserted when over-current occurs. A 8ms fault-blanking feature enables the circuit to ignore momentary faults, such as those caused when hot-swapping a capacitive load, preventing false alarms to the host system. The CXUS7743 eliminates any reversed current flow across each switch when it is powered off. The CXUS7743is available in MSOP-8 or SOP-8 package, operates over the extended (-40°C to +85°C) temperature range.

   产品特点 返回TOPcF9嘉泰姆


• 双通道100 mΩ High-Side MOSFETcF9嘉泰姆

• 1A限流电流,且具有fold-back功能cF9嘉泰姆

• 工作电压范围:2.7V to 5.5VcF9嘉泰姆

• 300μs 输出电压上升时间cF9嘉泰姆

• 欠压保护功能cF9嘉泰姆

• 15μA 静态电流cF9嘉泰姆

• 1μA 关断电流cF9嘉泰姆

• 低电平逻辑使能控制cF9嘉泰姆

• 芯片关断后没有反向电流cF9嘉泰姆

• 具有延时功能的开漏输出限流指示信号cF9嘉泰姆

• 8引脚SOP封装cF9嘉泰姆

• 符合RoHS规范及Pb-FreecF9嘉泰姆

 Dual 100m High-Side MOSFETcF9嘉泰姆

 Operating Range:2.7V to 5.5VcF9嘉泰姆

 300μS Typical Rise TimecF9嘉泰姆

 Under voltage LockoutcF9嘉泰姆

 15μA Quiescent Supply CurrentcF9嘉泰姆

 1μA Shutdown Supply CurrentcF9嘉泰姆

 Logic Level Enable Pin, Available withcF9嘉泰姆

Active-Low VersioncF9嘉泰姆

 No Reverse Current when Power OffcF9嘉泰姆

 Open-Drain Over-Current Flag Outputs withcF9嘉泰姆

fault-blankingcF9嘉泰姆

 Available in MSOP-8, SOP-8 and SOP-8(EP)cF9嘉泰姆

PackagescF9嘉泰姆

 RoHS Compliant and 100% Lead(Pb)-FreecF9嘉泰姆

Halogen-FreecF9嘉泰姆

 UL Listed-File No. E33429cF9嘉泰姆

   应用范围 返回TOPcF9嘉泰姆


• High-Side 电源开关cF9嘉泰姆

• USB 电源管理系统cF9嘉泰姆

• USB主机和自供电的总线系统cF9嘉泰姆

• USB总线供电系统cF9嘉泰姆

• 热插拔电源分配系统cF9嘉泰姆

• 电池充电系统cF9嘉泰姆

• 短路保护系统 cF9嘉泰姆

High-Side Power Protection Switch  cF9嘉泰姆

USB Power Management  cF9嘉泰姆

USB Host and Self-Powered Bubs  cF9嘉泰姆

USB Bus-Powered Hubs  cF9嘉泰姆

Hot Plug-In Power Supplies  cF9嘉泰姆

Battery-Charger Circuits  cF9嘉泰姆

Short-Circuit ProtectionscF9嘉泰姆

   技术规格书(产品PDF) 返回TOP cF9嘉泰姆


     需要详细的PDF规格书请扫一扫微信联系我们,还可以获得免费样品以及技术支持cF9嘉泰姆

 QQ截图20160419174301.jpgcF9嘉泰姆

产品封装图 返回TOPcF9嘉泰姆


acF9嘉泰姆

电路原理图 返回TOPcF9嘉泰姆


 cF9嘉泰姆

blob.png

相关芯片选择指南 返回TOP                     更多同类产品.....


功率开关   > USB开关cF9嘉泰姆

Part cF9嘉泰姆

NumbercF9嘉泰姆

remarkcF9嘉泰姆

ChannelcF9嘉泰姆

Vin (V)cF9嘉泰姆

RDS(ON)cF9嘉泰姆

ILMTcF9嘉泰姆

EnablecF9嘉泰姆

Fault FlagcF9嘉泰姆

IQ(A)cF9嘉泰姆

PackagecF9嘉泰姆

CXUS7743cF9嘉泰姆

Dual Power-Distribution Switch with Fault-BlankingcF9嘉泰姆

2cF9嘉泰姆

2.7~5.5cF9嘉泰姆

100mΩcF9嘉泰姆

1AcF9嘉泰姆

Active LowcF9嘉泰姆

YescF9嘉泰姆

13μAcF9嘉泰姆

SOP-8cF9嘉泰姆

CXUS7744cF9嘉泰姆

Dual Power-Distribution Switch with Fault-BlankingcF9嘉泰姆

2cF9嘉泰姆

2.7~5.5cF9嘉泰姆

95mΩcF9嘉泰姆

1AcF9嘉泰姆

Active LowcF9嘉泰姆

YescF9嘉泰姆

13μAcF9嘉泰姆

SOP-8,cF9嘉泰姆

SOP-8(EP)cF9嘉泰姆

CXUS7745cF9嘉泰姆

USB Power-Distribution Switch with Fault BlankingcF9嘉泰姆

1cF9嘉泰姆

2.7 ~ 5.5cF9嘉泰姆

100mΩcF9嘉泰姆

1.5A/2AcF9嘉泰姆

/2.5AcF9嘉泰姆

Active Low/Active HighcF9嘉泰姆

YescF9嘉泰姆

11μAcF9嘉泰姆

SOT23-5,MSOP-8,MSOP-8(EP)cF9嘉泰姆

CXUS7746cF9嘉泰姆

USB Power-Distribution Switch with Fault BlankingcF9嘉泰姆

1cF9嘉泰姆

2.7~5.5cF9嘉泰姆

80mΩcF9嘉泰姆

1.5AcF9嘉泰姆

Active HighcF9嘉泰姆

YescF9嘉泰姆

11μAcF9嘉泰姆

SOT23-5cF9嘉泰姆