Product information query
Products News
首页 > Products > Battery Charging Chip > USB Interface Circuit > Standard Smart Card Interface >CXRS3108异步模拟接口3或5伏智能卡放置在卡和微控制器之间 执行所有供电保护和控制功能三个特别保护的半双工双向缓冲I/O卡触点C4 C7和C8的线路26兆赫集成晶体振荡器
CXRS3108异步模拟接口3或5伏智能卡放置在卡和微控制器之间 执行所有供电保护和控制功能三个特别保护的半双工双向缓冲I/O卡触点C4 C7和C8的线路26兆赫集成晶体振荡器

CXRS3108是一个完整且经济的异步模拟接口
3或5伏智能卡。它可以放置在卡和微控制器之间
执行所有供电、保护和控制功能。很少有外部组件
是必需的

◆IC卡接口
◆IC(VDD和GND)的3或5 V电源
◆三个特别保护的半双工双向缓冲I/O
卡触点C4、C7和C8的线路
◆用于VCC产生的DC/DC转换器,分别由5 V±20%电源供电
(VDDP和PGND)
◆3或5 V±5%调节卡供电电压(VCC),具有适当的去耦功能,具有以下功能:
-VDDP=4至6.5 V时,ICC<80毫安
-处理高达20兆赫的40个nAs的当前峰值
-控制上升和下降时间
-在大约120毫安时过滤过载检测
◆所有卡触点的热保护和短路保护
◆自动激活和失活序列;由软件或
发生短路、卡取出、过热、VDD时的硬件
或VDDP退出
??加强卡侧ESD保护(>6KV)
◆26兆赫集成晶体振荡器
◆同步频率变化的高达20 MHz(通过CLKDIV1和CLKDIV2信号除以1、2、4或8)的卡时钟生成

CXRS3108异步模拟接口3或5伏智能卡放置在卡和微控制器之间 执行所有供电保护和控制功能三个特别保护的半双工双向缓冲I/O卡触点C4 C7和C8的线路26兆赫集成晶体振荡器
Manual
Ordering

Ordering

Product introduction

                          目录mWi嘉泰姆

   1.产品概述      2.产品特点      3.应用范围     4.技术规格书下载(PDF文档)mWi嘉泰姆

   5.产品封装      6.电路原理图     7.相关产品mWi嘉泰姆

一.产品概述mWi嘉泰姆


   The CXRS3108 is a complete and cost-efficient analog interface for asynchronousmWi嘉泰姆

3 or 5 V smart cards. It can be placed between the card and the microcontroller to mWi嘉泰姆

perform all supply, protection and control functions. Very few external components mWi嘉泰姆

are required  mWi嘉泰姆

二.产品特点mWi嘉泰姆


◆IC card interface  mWi嘉泰姆

◆3 or 5 V supply for the IC (VDD and GND)  mWi嘉泰姆

◆Three specifically protected half-duplex bidirectional buffered I/O mWi嘉泰姆

  lines to card contacts C4, C7 and C8  mWi嘉泰姆

◆DC/DC converter for VCC generation separately powered from a 5 V ± 20% supply mWi嘉泰姆

 (VDDP and PGND) mWi嘉泰姆

◆3 or 5 V ± 5% regulated card supply voltage (VCC) with appropriate decoupling has the  following capabilities:mWi嘉泰姆

 - ICC < 80 mA at VDDP = 4 to 6.5 V mWi嘉泰姆

 - Handles current spikes of 40 nAs up to 20 MHz mWi嘉泰姆

 - Controls rise and fall times mWi嘉泰姆

 - Filtered overload detection at approximately 120 mA  mWi嘉泰姆

◆Thermal and short-circuit protection on all card contacts  mWi嘉泰姆

◆Automatic activation and deactivation sequences; initiated by software or by mWi嘉泰姆

 hardware in the  event of a short-circuit, card take-off, overheating, VDD mWi嘉泰姆

 or VDDP drop-out  mWi嘉泰姆

◆Enhanced ESD protection on card side (>6 kV)  mWi嘉泰姆

◆26 MHz integrated crystal oscillator  mWi嘉泰姆

◆Clock generation for cards up to 20 MHz (divided by 1, 2, 4 or 8 through CLKDIV1 and CLKDIV2 signals) with synchronous frequency changes  mWi嘉泰姆

◆Non-inverted control of RST via pin RSTIN  mWi嘉泰姆

◆ISO 7816, GSM11.11 and EMV (payment systems) compatibility  mWi嘉泰姆

◆Supply supervisor for spike-killing during power-on and power-off and Power-on reset (threshold fixed internally or externally by a resistor bridge)  mWi嘉泰姆

◆Built-in debounce on card presence contacts  mWi嘉泰姆

◆One multiplexed status signal OFF  mWi嘉泰姆

◆Package:SOP28mWi嘉泰姆

三.应用范围mWi嘉泰姆


◆IC card readers for banking  mWi嘉泰姆

◆Electronic payment mWi嘉泰姆

◆Identification  mWi嘉泰姆

◆Pay TV   mWi嘉泰姆

四.技术规格书(产品PDF)mWi嘉泰姆


需要详细的PDF规格书请扫一扫微信联系我们,还可以获得免费样品以及技术支持!mWi嘉泰姆

 QQ截图20160419174301.jpgmWi嘉泰姆

五.产品封装图mWi嘉泰姆


 blob.png mWi嘉泰姆

六.电路原理图mWi嘉泰姆


 blob.png  mWi嘉泰姆

七.相关芯片选择指南mWi嘉泰姆


标准智能卡接口电路(Standard   Smart Card Interface)
Part   No. Features VDD Package Reference
CXRS3108 Analog Interface For Asynchronous 3 Or 5V Smart   Cards 2.7~6.5V SOP28 TDA8024