首页 > Products > Battery Charging Chip > Voltage Detector/RESET IC > Voltage Detector And RESET IC >CXDR7517超低功耗电池监测仪监测单个多个锂离子电池多个碱性电池镍镉电池镍氢电池和多个铅酸电池CMOS输出消除输出颤振的滞环电源瞬态抗扰度
CXDR7517超低功耗电池监测仪监测单个多个锂离子电池多个碱性电池镍镉电池镍氢电池和多个铅酸电池CMOS输出消除输出颤振的滞环电源瞬态抗扰度
CXDR7517是一款超低功耗电池监视器，专门用于监测单或多锂离子电池、多电池碱性电池、镍镉电池、镍氢电池和多电池铅酸电池。该设备提供单电池低输出和具有固定滞后。磁滞消除了有时与蓄电池电压监测器相关的输出抖动，通常是由于输入电压噪声或负载消除后蓄电池端子电压恢复引起的。
Manual
-
[ CXDR7517 ]"
Ordering
Product introduction
目录
产品概述 返回TOP
The CXDR7517 is an ultra low power battery monitor,and is specially designed for monitoring single or multi lithium-ion (Li+) cells, multi-cell alkaline,NiCd, NiMH and multi-cell lead acid batteries.The device offers a single low-battery output and
features fixed hysteresis. The hysteresis eliminates the output chatter sometimes associated with battery voltage monitors, usually due to input voltage noise or battery terminal voltage recovery after load removal.
The device is available in 5 pin SOT23 package and is fully specified over the -40°C to +85°C extended temperature range.
产品特点 返回TOP
Precise Reset Threshold: ±2%
Hysteresis to Eliminate the Output Chatter
CMOS Output
60ms typical Delay to Filter out the noise
1.8μA Supply Current @VCC=3V
Guaranteed Output Valid to VCC = +1.15V
Power Supply Transient Immunity
Operating Temperature Range
-40°C to +85°C
Available in SOT23-5
应用范围 返回TOP
Battery-powered Systems
Multi-cell Li+ Batteries Monitoring
Multi-cell Alkaline, NiCd or NiMH Batteries Monitoring
Multi-cell Lead Acid Batteries Monitoring
技术规格书（产品PDF) 返回TOP
需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！
产品封装图 返回TOP
| Pin No. | Symbol | Description |
| 1 | GND | Negative Terminal of Power Supply(Ground) |
| 2 | VCC | Positive Terminal of Power Supply. This pin is the power supply to internal circuit. |
| 3 | LBO | Low Battery Output. CMOS output. If the voltage at LBI pin is higher than the rising threshold for more than 60ms typical, LBO will transition to high; If the voltage at LBI pin is lower than the falling threshold, LBO will transition to low. |
| 4 | LBI | Low Battery Input. The voltage that needs to be monitored is sensed at this pin. Generally LBI pin should be tied to an external resistor divider to sense the battery voltage. |
| 5 | NC | No Connection. |
电路原理图 返回TOP
相关芯片选择指南 返回TOP 更多同类产品.......
| 低电压检测IC(复位IC) | |||||
| 型号 | 输入耐压 | 检测电压精度 | 输出形式 | 工作电流 | 封装 |
| CXDR7517 | 6.5V | 2% | CMOS | 1.8uA | SOT-25 |
| CXDR7518 | 1.5-8V | 2% | CMOS/N沟道反相 | 4uA | SOT-25 |
| CXDR7516C | 12V | 2% | CMOS/N沟道 | 1.1uA | SOT-23 |
| CXDR7524 | 6V | 2% | CMOS/高有效和低有效/带手动复位 | 52uA | SOP8 |
| CXDR7523L | 6V | 2% | CMOS/高有效/带手动复位/带看门狗 | 52uA | SOP8 |
| CXDR7521 | 6V | 1% | N沟道/低有效 | 1.0uA | SOT-23 |
| CXDR7519 | 6V | 1% | CMOS/低有效 | 1.0uA | SOT-23 |
| CXDR7520 | 6V | 2% | CMOS/低有效 | 8.0uA | SOT-23 |
| CXDR7522 | 6V | 2% | CMOS/低有效/带手动复位 | 8.0uA | SOT-143 |
