• [ CXUS7719 ]"

Ordering

                          目录MTf嘉泰姆

   1.产品概述      2.产品特点      3.应用范围     4.技术规格书下载（PDF文档）MTf嘉泰姆

   5.产品封装      6.电路原理图     7.相关产品MTf嘉泰姆

一.产品概述MTf嘉泰姆

         The CX8PU86LV  CXUS7719 has program memory size greater 2K works, but the CALL and GOTO instructions only have a 11-bits address range. This 11-bit address range allows a branch within a 2K program memory page size. To allow CALL and GOTO instructions to address the entire 6K program memory address range for CX8PU86LV  CXUS7719, there is another two bits to specify the program memory page. The paging bit comes from the ROMBANK[1:0] bits(PUMODE[6:5]). When doing a CALL or GOTO instruction, the user must ensure that page bit ROMBANK[1:0] are programmed so that the desired program memory page is addressed. When one of return instructions is executed, the entire 13-bit PC is POPed from the stack. Therefore, manipulation of the ROMBANK[1:0] is not required for return instructions MTf嘉泰姆

二.产品特点MTf嘉泰姆

USB Specification ComplianceMTf嘉泰姆

Support Full-Speed and Low-Speed USB 2.0 specification.MTf嘉泰姆

Built-in USB Transceiver.MTf嘉泰姆

Built-in 1.5k pull-high resistor.MTf嘉泰姆

Support one address and four 8-byte and two 32-byte data endpoints.MTf嘉泰姆

Support USB Suspend and Resume function.MTf嘉泰姆

One Control IN/OUT endpoints, two INT,BULK endpoints.MTf嘉泰姆

8-bit RISC microprocessorMTf嘉泰姆

6K x 14 internal program OTP-ROM.MTf嘉泰姆

256 bytes internal SRAM.MTf嘉泰姆

Optional 12MHz/24MHz internal MCU clock by configuration.MTf嘉泰姆

Optional Default/16MHz/12MHz/6MHz/58KHz internal MCU clock by firmware.MTf嘉泰姆

One Watch dog Timer ,Timer0,Timer1,and two captures Timers.MTf嘉泰姆

System ClockMTf嘉泰姆

Internal OscillatorMTf嘉泰姆

Internal +/- 4% 24MHz OscillatorMTf嘉泰姆

0.25% Accuracy after USB traffic is received.MTf嘉泰姆

Internal slow oscillator 58KHz free run clock for suspend mode.MTf嘉泰姆

Built-in flexible programming PLL for external Oscillator or crystalMTf嘉泰姆

Operating Frequency Range of Oscillator/crystal is 2~48 MHz.MTf嘉泰姆

Optional external ceramic resonator or internal clock mode..16-I/O portsMTf嘉泰姆

High current drive on any GPIO pin : 25mA/pin current sink.MTf嘉泰姆

Each GPIO pin supports high-impedance input, internal pull-ups,MTf嘉泰姆

open drains output, or CMOS outputs.MTf嘉泰姆

Power Manager and consumptionMTf嘉泰姆

Power on reset (POR) is 2.0VMTf嘉泰姆

Chip can work on greater than 2.2V power.MTf嘉泰姆

Low Voltage Detect is 3.8VMTf嘉泰姆

Regulator 3.3V output, supply 45mA current.MTf嘉泰姆

MCU operating at 24MHz clockMTf嘉泰姆

Enable USB operating current is 17mA as Vcc=5V.MTf嘉泰姆

Disable USB operating current is 6mA as Vcc=3.3V.MTf嘉泰姆

MCU operating at 12MHz clockMTf嘉泰姆

Enable USB operating current is 13mA as Vcc=5V.MTf嘉泰姆

Disable USB operating current is 4mA as Vcc=3.3VMTf嘉泰姆

GPIO supply 1.8V~5V interface.MTf嘉泰姆

Support SSC to reduce EMI.MTf嘉泰姆

三.应用范围MTf嘉泰姆

The CX8PU86LV  CXUS7719 is an 8-bit microprocessor embedded device tailored to the MTf嘉泰姆

  USB application. It includes an 8-bit RISC CPU core, 192~256 byte SRAM, Full Speed and MTf嘉泰姆

Low Speed USB Interface and a 6K x 14 internal program OTP-ROM.  MTf嘉泰姆

四.技术规格书（产品PDF)MTf嘉泰姆

需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！MTf嘉泰姆

 MTf嘉泰姆

五.产品封装图MTf嘉泰姆

  MTf嘉泰姆

六.电路原理图MTf嘉泰姆

   MTf嘉泰姆

七.相关芯片选择指南          更多同类产品......MTf嘉泰姆

◀ Previous:USB 1.X Controller with 6K OTP ROM,CXUS7718 CXUS7719 has program memory size greater 2K works, but the CALL and GOTO instructions only have a 11-bits address range.

Back to top

Next▶:Cxmc3328 cxmc3329 is an 8-bit high performance, high efficiency mixed signal microcontroller (MCU) programmable 4K byte OTP ROM It provides great convenience for users