• [ CXUS7718 ]"

Ordering

                          目录vP5嘉泰姆

   1.产品概述      2.产品特点      3.应用范围     4.技术规格书下载（PDF文档）vP5嘉泰姆

   5.产品封装      6.电路原理图     7.相关产品vP5嘉泰姆

一.产品概述vP5嘉泰姆

         The CX8PU86LV  CXUS7719 has program memory size greater 2K works, but the CALL and GOTO instructions only have a 11-bits address range. This 11-bit address range allows a branch within a 2K program memory page size. To allow CALL and GOTO instructions to address the entire 6K program memory address range for CX8PU86LV  CXUS7719, there is another two bits to specify the program memory page. The paging bit comes from the ROMBANK[1:0] bits(PUMODE[6:5]). When doing a CALL or GOTO instruction, the user must ensure that page bit ROMBANK[1:0] are programmed so that the desired program memory page is addressed. When one of return instructions is executed, the entire 13-bit PC is POPed from the stack. Therefore, manipulation of the ROMBANK[1:0] is not required for return instructions vP5嘉泰姆

二.产品特点vP5嘉泰姆

USB Specification CompliancevP5嘉泰姆

Support Full-Speed and Low-Speed USB 2.0 specification.vP5嘉泰姆

Built-in USB Transceiver.vP5嘉泰姆

Built-in 1.5k pull-high resistor.vP5嘉泰姆

Support one address and four 8-byte and two 32-byte data endpoints.vP5嘉泰姆

Support USB Suspend and Resume function.vP5嘉泰姆

One Control IN/OUT endpoints, two INT,BULK endpoints.vP5嘉泰姆

8-bit RISC microprocessorvP5嘉泰姆

6K x 14 internal program OTP-ROM.vP5嘉泰姆

256 bytes internal SRAM.vP5嘉泰姆

Optional 12MHz/24MHz internal MCU clock by configuration.vP5嘉泰姆

Optional Default/16MHz/12MHz/6MHz/58KHz internal MCU clock by firmware.vP5嘉泰姆

One Watch dog Timer ,Timer0,Timer1,and two captures Timers.vP5嘉泰姆

System ClockvP5嘉泰姆

Internal OscillatorvP5嘉泰姆

Internal +/- 4% 24MHz OscillatorvP5嘉泰姆

0.25% Accuracy after USB traffic is received.vP5嘉泰姆

Internal slow oscillator 58KHz free run clock for suspend mode.vP5嘉泰姆

Built-in flexible programming PLL for external Oscillator or crystalvP5嘉泰姆

Operating Frequency Range of Oscillator/crystal is 2~48 MHz.vP5嘉泰姆

Optional external ceramic resonator or internal clock mode..16-I/O portsvP5嘉泰姆

High current drive on any GPIO pin : 25mA/pin current sink.vP5嘉泰姆

Each GPIO pin supports high-impedance input, internal pull-ups,vP5嘉泰姆

open drains output, or CMOS outputs.vP5嘉泰姆

Power Manager and consumptionvP5嘉泰姆

Power on reset (POR) is 2.0VvP5嘉泰姆

Chip can work on greater than 2.2V power.vP5嘉泰姆

Low Voltage Detect is 3.8VvP5嘉泰姆

Regulator 3.3V output, supply 45mA current.vP5嘉泰姆

MCU operating at 24MHz clockvP5嘉泰姆

Enable USB operating current is 17mA as Vcc=5V.vP5嘉泰姆

Disable USB operating current is 6mA as Vcc=3.3V.vP5嘉泰姆

MCU operating at 12MHz clockvP5嘉泰姆

Enable USB operating current is 13mA as Vcc=5V.vP5嘉泰姆

Disable USB operating current is 4mA as Vcc=3.3VvP5嘉泰姆

GPIO supply 1.8V~5V interface.vP5嘉泰姆

Support SSC to reduce EMI.vP5嘉泰姆

三.应用范围vP5嘉泰姆

The CX8PU86LV  CXUS7719 is an 8-bit microprocessor embedded device tailored to the vP5嘉泰姆

  USB application. It includes an 8-bit RISC CPU core, 192~256 byte SRAM, Full Speed and vP5嘉泰姆

Low Speed USB Interface and a 6K x 14 internal program OTP-ROM.  vP5嘉泰姆

四.技术规格书（产品PDF)vP5嘉泰姆

需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！vP5嘉泰姆

 vP5嘉泰姆

五.产品封装图vP5嘉泰姆

  vP5嘉泰姆

六.电路原理图vP5嘉泰姆

   vP5嘉泰姆

七.相关芯片选择指南          更多同类产品......vP5嘉泰姆

◀ Previous:Full-Speed USB Controller The CXUS7717 has program memory size greater 2K works, but the CALL and GOTO instructions only have a 11-bits address range. This 11-bit address range allows a branch withi

Back to top

Next▶:USB 1.X Controller with 6K OTP ROM,CXUS7718 CXUS7719 has program memory size greater 2K works, but the CALL and GOTO instructions only have a 11-bits address range.