• "

Ordering

目录Cyj嘉泰姆

1.产品概述                       2.产品特点Cyj嘉泰姆
3.应用范围                       4.下载产品资料PDF文档 Cyj嘉泰姆
5.产品封装图                     6.电路原理图                   Cyj嘉泰姆
7.功能概述                        8.相关产品Cyj嘉泰姆

 Cyj嘉泰姆

一,产品概述(General Description)         Cyj嘉泰姆
   CXSU63039 is a high efficiency synchronous boost regulator that convertsCyj嘉泰姆

down to 2.5V input and up to 5.5V output voltage. It adopts NMOS for theCyj嘉泰姆

main switch and PMOS for the synchronous switch. It can disconnect the Cyj嘉泰姆

output from input during the shutdown mode..Cyj嘉泰姆

  It integrates 5A power MOSFET and can output 5V 2.5A with Li-Battery input.Cyj嘉泰姆
二.产品特点(Features)Cyj嘉泰姆
1.)2.5V Minimum input voltageCyj嘉泰姆
2.)Adjustable output voltage from 3V to 5.5VCyj嘉泰姆
3.)6A peak current limitCyj嘉泰姆
4.)Input under voltage lockoutCyj嘉泰姆
5.)600Khz fixed Switching FrequencyCyj嘉泰姆
6.)Load disconnect during shutdownCyj嘉泰姆
7.)Integrated soft-startCyj嘉泰姆
8.)Output over voltage protectionCyj嘉泰姆
30moJTM Power MOSFETCyj嘉泰姆
Thermal ShutdownCyj嘉泰姆
QFN4x4-16 PackageCyj嘉泰姆
三,应用范围 (Applications)Cyj嘉泰姆
1.) Handheld DevicesCyj嘉泰姆
2.)Power BankCyj嘉泰姆
3.)All Single Cell Li or Dual Cell Battery Operated ProductsCyj嘉泰姆
四,产品封装图 (Package)Cyj嘉泰姆
Cyj嘉泰姆
Cyj嘉泰姆

五,电路原理图Cyj嘉泰姆
Cyj嘉泰姆
Cyj嘉泰姆
Cyj嘉泰姆
六.产品PDF文档Cyj嘉泰姆

需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！Cyj嘉泰姆

 Cyj嘉泰姆

七,功能概述Cyj嘉泰姆

SYNCHRONOUS RECTIFIERCyj嘉泰姆
The device integrates an N-channel and a P-channel MOSFET transistor to realize aCyj嘉泰姆
synchronous rectifier. Because the commonly used discrete Schottky rectifier is replaced withCyj嘉泰姆
a low RDS(ON) PMOS switch, the power conversion efficiency reaches 96%. To avoidCyj嘉泰姆
ground shift due to the high currents in the NMOS switch, two separate ground pins are used.Cyj嘉泰姆
The reference for all control functions is the GND pin. The source of the NMOS switch isCyj嘉泰姆
connected to PGND. Both grounds must be connected on the PCB at only one point close toCyj嘉泰姆
the GND pin. A special circuit is applied to disconnect the load from the input duringCyj嘉泰姆
shutdown of the converter. In conventional synchronous rectifier circuits, the backgate diodeCyj嘉泰姆
of the high-side PMOS is forward biased in shutdown and allows current flowing from theCyj嘉泰姆
battery to the output. This device however uses a special circuit which takes the cathode ofCyj嘉泰姆
the backgate diode of the high-side PMOS and disconnects it from the source when theCyj嘉泰姆
regulator is not enabled (EN = low).Cyj嘉泰姆
The benefit of this feature for the system design engineer is that the battery is not depletedCyj嘉泰姆
during shutdown of the converter. No additional components have to be added to the designCyj嘉泰姆
to make sure that the battery is disconnected from the output of the converter.Cyj嘉泰姆
八,相关产品           更多同类产品........    Cyj嘉泰姆

Cyj嘉泰姆

◀ Previous:CXSU63038A high efficiency synchronous boost regulator that converts down to 2.5V input and up to 5.5V output voltage. It adopts NMOS for the main switch and PMOS for the synchronous switch

Back to top

Next▶:5V 6A 1.2MHz Synchronous Boost Converter CXSU63040 is a synchronous rectifier,fixed switching frequency and current‐mode step‐up regulator. The device allows use of small inductors