• "

Ordering

目录

1.产品概述       2.产品特点     iyl嘉泰姆

3.应用范围       4.技术规格书下载（PDF文档）iyl嘉泰姆

5.产品封装       6.电路原理图  iyl嘉泰姆

7.相关产品iyl嘉泰姆

   产品概述 返回TOPiyl嘉泰姆

The CXLB7384 is a compact, flexible, high‐efficiency, USB‐friendly switch‐mode charge management device for single‐cell Li‐ion and Li‐polymer batteries used in a wide range of portable applications. The charge parameters can be programmed through an I 2 C interface. The IC integrates a synchronous PWM controller, power MOSFETs, input current sensing, high‐accuracy current and voltage regulation, and charge termination, into a small WCSP package.    The IC charges the battery in three phases: conditioning, constant current and constant voltage. The input current is automatically limited to the value set by the host. Charge is terminated based on battery voltage and user‐selectable minimum current level. A safety timer with reset control provides a safety backup for I 2 C interface. During normal operation, The IC automatically restarts the charge cycle if the battery voltage falls below an internal threshold and automatically enters sleep mode or high impedance mode when the input supply is removed. The charge status can be reported to the host using the I 2 C interface. During the charging process, the IC monitors its junction temperature (TJ) and reduces the charge current once TJ increases to about 125°C. To support USB OTG device, CXLB7384 can provide VBUS (5.05V) by boosting the battery voltage. The IC is available in 20‐pin WCSP package.   

   产品特点 返回TOPiyl嘉泰姆

z Power Up System without Battery    iyl嘉泰姆

z Charge Faster than Linear Chargers    iyl嘉泰姆

z High‐Accuracy Voltage and Current Regulation    iyl嘉泰姆

Input Current Regulation Accuracy: ±5%(100 mA and 500 mA)    iyl嘉泰姆

Charge Voltage Regulation Accuracy:    ±0.5% (25°C), ±1% (0°C to 125°C)Charge Current Regulation Accuracy: ±5%    iyl嘉泰姆

z Input Voltage Based Dynamic Power Management (VIN DPM) iyl嘉泰姆

z Bad Adaptor Detection and Rejection iyl嘉泰姆

z Safety Limit Register for Maximum Charge Voltage and Current Limiting    iyl嘉泰姆

z High‐Efficiency Mini‐USB/AC Battery Charger for Single‐Cell Li‐Ion and Li‐Polymer Battery    Packs    iyl嘉泰姆

z 20‐V Absolute Maximum Input Voltage Rating    iyl嘉泰姆

z 6.5‐V Maximum Operating Input Voltage    iyl嘉泰姆

z Built‐In Input Current Sensing and Limiting    iyl嘉泰姆

z Integrated Power FETs for Up To 1.25‐A Charge Rate    iyl嘉泰姆

z Programmable Charge Parameters through I 2 C™ Compatible Interface (up to 3.4 Mbps):   iyl嘉泰姆

 Input Current Limit VIN DPM Threshold    iyl嘉泰姆

Fast‐Charge/Termination Current    iyl嘉泰姆

Charge Regulation Voltage (3.5 V to 4.44 V)    iyl嘉泰姆

Low Charge Current Mode Enable/Disable   iyl嘉泰姆

Termination Enable/Disable    iyl嘉泰姆

z Synchronous Fixed‐Frequency PWM Controller Operating at 3 MHz With 0% to 99.5% Duty Cycle z Automatic High Impedance Mode for Low Power Consumption    iyl嘉泰姆

z Robust Protection    iyl嘉泰姆

Reverse Leakage Protection Prevents Battery Drainage Thermal Regulation and Protection   iyl嘉泰姆

 Input/Output Overvoltage Protection    iyl嘉泰姆

z Status Output for Charging and Faults   iyl嘉泰姆

 z USB Friendly Boot‐Up Sequence iyl嘉泰姆

z Automatic Charging    iyl嘉泰姆

z Boost Mode Operation for USB OTG    iyl嘉泰姆

Input Voltage Range (from Battery): 3.2 V to 4.5V iyl嘉泰姆

z 2.1 mm x 2 mm 20‐Pin WCSP Packageiyl嘉泰姆

   应用范围 返回TOPiyl嘉泰姆

z Mobile and Smart Phones iyl嘉泰姆

z M3 Players    iyl嘉泰姆

z Handheld Devices   iyl嘉泰姆

   技术规格书（产品PDF) 返回TOP iyl嘉泰姆

     需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！iyl嘉泰姆

 iyl嘉泰姆

产品封装图 返回TOPiyl嘉泰姆

iyl嘉泰姆

电路原理图 返回TOiyl嘉泰姆

iyl嘉泰姆

 iyl嘉泰姆

相关芯片选择指南 返回TOP             更多同类产品......        

◀ Previous:1A Standalone Linear Li-lon Battery Charger with Thermal Regulation CXLB7383 is a complete constant‐current/constant‐voltage linear charger for single cell lithium‐ion batteries.

Back to top

Next▶:CXLB7257 CXLB7257B complete battery charger controller for one (4.22V) cell lithium-ion battery provides a small simple and efficient solution to fast charge Li-ion battery